Viking Platinum 16 Guida Utente Scaricare il pdf (Pagina 14)

14

Tips and Techniques

1.

Don’t twist the fabric under the

needle, as this will cause the needle

to sew faster or slower than it should

and you will not maintain regulation.

As long as the fabric remains in the

same orientation relative to your body

while quilting, the regulation will be

accurate.

2. When you have ﬁnished a section

of quilting, readjust the position of

the TruStitch™ controller to make

the next section easier to work on.

Don’t try to quilt large sections of the

quilt at one time. Work within a space

no farther out than 6”-15” from the

needle.

3. Idle speed can help you keep the

needle in motion and prevent long

stitches e.g. when doing zigzag, star

or circular patterns.

4. Adjusting your Idle speed will

give you better results. Experiment

with different percentages to ﬁnd the

level you like best for each quilting

method. For example, micro-stippling

with a high stitches-per-inch count

will require a higher percentage set-

ting than stitch-in-the-ditch.

5. When using rulers hold the con-

troller next to the ruler and move the

ruler with both hands. As you adjust

the ruler, adjust the controller as

well. Some quilters prefer to use the

magnet when doing ruler work. Don’t

forget to release the foot pedal or

press the Pause button before moving

the controller.

6. A hoop may be used in conjunc-

tion with the controller for better

control of the fabric being sewn. You

can hold the controller just outside of

the hoop with your hand or with the

magnet.

7. If you are using a higher stitches-

per-inch setting and the Idle speed

is set to zero, it is recommended that

you keep the controller closer to the

needle. Be careful not to let the con-

troller hang up on the needle plate.

8. Because the controller senses

its motion across the table top, it is

important that it never be allowed to

pass over the gap in the table behind

the needle where the PLATINUM™

16 quilting machine arm is placed.

This gap will cause a break in the

information sent to the receiver and

will result in uneven stitches.

For the same reason, make sure the

controller doesn’t extend past the

edge of the table (which could hap-

pen when using the coaster).

Register your TruStitch™

For product and warranty registration,

go to the HUSQVARNA VIKING® web

site at www.husqvarnaviking.com.

1 2 ... 9 10 11 12 13 14 15 16

Commenti su questo manuale

Nessun commento