Viking VBCV Manuale Utente Scaricare il pdf

READ AND SAVE THESE INSTRUCTIONS

MODEL VEV1200

EXTERIOR MOUNTED BLOWER

FOR USE WITH VIKING VWH, VIH, VBCV, VICV AND DTWN

24" TO 66" WIDE, 18" HIGH RANGE HOODS

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR

INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manu-

facturer. If you have questions, contact the manufac-

turer or your distributor.

2. Before servicing or cleaning unit, switch power off at

service panel and lock the service disconnecting means

to prevent power from being switched on accidentally.

When the service disconnecting means cannot be locked,

securely fasten a prominent warning device, such as a

tag, to the service panel.

3. Installation work and electrical wiring must be done by a

qualified person(s) in accordance with all applicable

codes and standards, including fire-rated construction

codes and standards.

4. Sufficient air is needed for proper combustion and

exhausting of gases through the flue (chimney) of fuel

burning equipment to prevent backdrafting. Follow the

heating equipment manufacturer's guideline and safety

standards such as those published by the National Fire

Protection Association (NFPA), and the American Soci-

ety for Heating, Refrigeration and Air Conditioning Engi-

neers (ASHRAE), and the local code authorities.

CAUTION

1. For general ventilating use only. Do not use to exhaust hazard-

ous or explosive material and vapors.

2. To avoid motor bearing damage and noisy and/or unbalanced

impellers, keep drywall spray, construction dust, etc. off power

unit.

3. Please read specification label on product for further informa-

tion and requirements.

4. Electrical circuit, including speed control, (if used), must be

rated 6 AMPS minimum.

Blower Dimensions

22 x 30.828 x 12.724

PLAN THE

INSTALLATION

1. Locate the blower so the

length of the duct run and

number of elbows needed

are kept to a minimum.

2. Where possible, blower

should be centered be-

tween wall studs or roof

rafters.

3. Avoid pipes, wires, or

other ductwork that may

be running through the wall.

ALL INSTALLATIONS

MODEL VOLTS AMPS CFM DUCT SIZE

VEV1200 120 3.0 1200 10" DIA.

SPECIFICATIONS

INSTALLER: Leave This Manual With The Homeowner

HOMEOWNER: Use And Care Information On Page 4

MODEL VEV1200

EXTERIOR BLOWER

WALL HOOD

CANOPY

(island canopy

available)

10" ROUND

DUCT

SOFFIT

ROUGH-IN

PLATE

24" or 27"

18"

MODEL

VEV1200

EXTERIOR

BLOWER

WALL HOOD

CANOPY

(island canopy

available)

10" ROUND DUCT

SOFFIT

ROUGH-IN

PLATE

24" or 27"

18"

10" ROUND ELBOW

TYPICAL ROOF MOUNTED INSTALLATION TYPICAL WALL MOUNTED INSTALLATION

5. When cutting or drilling into wall, or ceiling, do not

damage electrical wiring or other hidden utilities.

6. Ducted fans must always be vented to the outdoors.

7. To reduce risk of fire, use only metal ductwork.

8. This unit must be grounded.

WARNING

1 2 3 4 5 6 7 8

Sommario

Pagina 1 - EXTERIOR MOUNTED BLOWER

1READ AND SAVE THESE INSTRUCTIONSMODEL VEV1200EXTERIOR MOUNTED BLOWERFOR USE WITH VIKING VWH, VIH, VBCV, VICV AND DTWN24" TO 66" WIDE, 18&qu

Pagina 2 - LOCATION

211" dia.hole22"Guide hole(centered between studs)22"29½"29½"1411/16"1113/16"1113/16"17"Wall StudWall Stu

Pagina 3 - INSTALL THE BLOWER

31. Remove the cover and screws.2. Attach an appropriate U.L. approved cable connectorin the hole at the rear of the wiring box.3. Remove roofing nail

Pagina 4 - VIKING RANGE CORPORATION

4GREENWHITEBLACKBLACKWHITEGREENBLACKWHITEGREENROUGH-IN PLATE LEADROUGH-IN PLATE LEADWIRING BOXEXTERIORBLOWERBLACKBLACKBROWNCAPACITORWHITEBLUEBLACKGREE

Pagina 5

5OBSERVEZ LES DIRECTIVES CI-DESSOUS DEMANIÈRE À RÉDUIRE LES RISQUES D’INCENDIE, DECHOC ÉLECTRIQUE OU DE BLESSURESCORPORELLES.1. N’utilisez cet apparei

Pagina 6 - L’EMPLACEMENT DE POSE

611" dia.hole20½"11" dia.hole1"ØØ911/16"20½"ØØ15"913/16"18"1211/16"1¼" dia. hole1¼" dia. h

Pagina 7 - POSE DU VENTILATEUR

71. Retirez le couvercle et les vis.2. Fixez un connecteur de câble homologué U.L.dansl’ouverture à l’arrière du boîtier de câblage.3. Retirez seuleme

Pagina 8 - UTILISATION ET ENTRETIEN

8GREENWHITEBLACKBLACKWHITEGREENBLACKWHITEGREENROUGH-IN PLATE LEADROUGH-IN PLATE LEADWIRING BOXEXTERIORBLOWERBLACKBLACKBROWNCAPACITORWHITEBLUEBLACKGREE